Skyteks awning is designed as a 400 facade 600 opening/unsupported; 400 facade 1050 opening/supported 1 module. The special design awning’s slope profile is 163.5×156 mm in size and weighs 7240 gr/m. The beam profile is 136.5×30 mm in size and weighs 2510 gr/m. The special design awning reaches a total cross-section height of 30 cm. The concept awning prevents potential water overflow with its slope profiles and wide reservoir. When the profiles are connected, they create unity and are integrated with a double-claw lock system. This results in high strength, allowing for long openings. The column profile is 160×160 mm in size and weighs 6050 gr/m. Skyteks awning is installed with PVC pipes inside the area where water drainage will take place, and the water from the gutter is discharged with the help of PVC.
The columns are connected to the ground with a 6 mm aluminum flange, hiding the screw appearance that would disrupt aesthetics. The use of stainless bolts and drain in the columns prevents oxidation. Panel profiles are 20.6 mm in width and weigh 4630 gr/m. The special design awning prevents water accumulation with the hidden slope inside the panel. The special reservoir structure on the top of the panel prevents substances that may accumulate on the system from falling inside during the opening of the system. The practical special design awning provides lighting and ventilation with its privileged panels by opening with a single point movement. To make this movement, the profile to which the panels are attached is lifted with a high-pressure piston motor.